Your shopping cart is empty!
Categories
- Batteries (119)
- Chargers (15)
-
Components (133)
- - AMC7135 / MOSFET (6)
- - Battery Carriers (1)
- - Battery Tubes / Extension Tubes (11)
- - Driver Adapters / PCB Partition Boards (0)
- - Driver DIY Parts Kits (8)
- - Driver PCBs / Exp. Boards (22)
- - Electrical Components / MCUs (16)
- - Hardware / Screws (1)
- - Holsters (2)
- - LED Insulation Gaskets / Reflector Spacers (8)
- - Lubricants (1)
- - Magnets (0)
- - Pocket Clips (3)
- - Rubber Switch Boots (1)
- - Shrink Tubing (1)
- - Silicone / Teflon Wire (8)
- - Soldering Products / Solder Wick (5)
- - Spacers (4)
- - Springs / Brass Buttons (6)
- - Switches (8)
- - Thermal Products (5)
- Flashlight Hosts (31)
- Flashlights (28)
- LEDs (207)
- MCPCBs (30)
- Optics (28)
- Other (7)
- P60 (9)
- Drivers (89)
Suggested Bundles
Convoy S6 Flashlight Host
Price: $10.45
The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.
This is one of my favorite EDC hosts! This host has nice anodizing, small size, and great threads. Only unprotected cells will fit in this body. The OP reflector produces a nice smooth beam with a diffuse hotspot. Just add a 16mm MCPCB with LED, 17mm driver, a bit of solder, and you'll be in business!
We also offer a great holster for this flashlight. Click here to see it!
Add an AR lens for an up to 5-10% gain in "out the front" lumens.
Custom Build Service ***CURRENTLY UNAVAILABLE***
For an added cost, I will build and test this light for you. Just check the box and also add your choice of 17mm driver and 16mm LED (except MT-G2/XHP70) to your shopping cart. If you add more than one LED or driver please specify in the comments section of your order which you would like me to use in the light. This service may add 4-5 weeks to your total order shipment time.
What's Included:
- Convoy S6 Body / Lens / Reflector
- Plastic Reflector Insulator/Spacer
- Plenty of O-rings
- Two Springs
- Switch and Associated Parts
- Contact Board
- Lanyard
Specifications:
- Length: 120mm
- Diameter: 24mm
- Weight: 68 grams
- MCPCB required: 16mm
- Driver diameter required: 17mm
- Reflector finish: Orange Peel
- Glow-in-the-dark Switch Boot
Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below:
© Mountain Electronics LLC