Your shopping cart is empty!
Categories
- Batteries (118)
- Chargers (16)
-
Components (132)
- - AMC7135 / MOSFET (6)
- - Battery Carriers (1)
- - Battery Tubes / Extension Tubes (11)
- - Driver Adapters / PCB Partition Boards (0)
- - Driver DIY Parts Kits (8)
- - Driver PCBs / Exp. Boards (22)
- - Electrical Components / MCUs (16)
- - Hardware / Screws (1)
- - Holsters (2)
- - LED Insulation Gaskets / Reflector Spacers (8)
- - Lubricants (1)
- - Magnets (0)
- - Pocket Clips (3)
- - Rubber Switch Boots (1)
- - Shrink Tubing (1)
- - Silicone / Teflon Wire (8)
- - Soldering Products / Solder Wick (5)
- - Spacers (4)
- - Springs / Brass Buttons (6)
- - Switches (7)
- - Thermal Products (5)
- Flashlight Hosts (31)
- Flashlights (29)
- LEDs (211)
- MCPCBs (30)
- Optics (28)
- Other (7)
- P60 (9)
- Drivers (85)
Suggested Bundles
Nanjg 101-AK-A1 7135*4 1.4A LED DRIVER
Product Code: 101-AK-A1
Availability: 20
Availability: 20
Price: $3.45
3 or more $3.25
Qty:
- OR -
Add to Wish List
Add to Compare
Add to Compare
This is a great driver when you need a single sided low profile 17mm driver for your project.
You can increase or decrease the output current by adding or removing 7135 chips, each chip adds or subtracts around .350mA. I sell these chips as an add on for DIY or offer them pre-installed, ready-to-run, for an additional cost. See pull down option for cost for this services. The addition of these services may extend handling time 1-10 days.
Features:
*Input voltage: 2.8V - 4.5V
*Current: 1.4A
*Constant current
*PCB diameter: 17mm
*PCB thickness: 1.2mm
*Components height: 1.5mm
*Memory function (sets in after 2 seconds)
*No LED Leads Included
*Reverse polarity protection
*Gold plated contacts
*Low voltage warning: At 2.9-3V the light will blink once per second.
Mode groups:
Default: 100% - 33% - 5% - Strobe - SOS
Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below:
© Mountain Electronics LLC